Specifications

STEP 3: Note the orientation notch in J6 and orient the replacement
Wipe Generator sub-board to match. Seat the sub-board on
the connector and press gently but firmly directly over the
connector area so as not to unduly flex the Switcher board.
Fix the standoff fastening screws to secure the sub-board. Use
the Accom supplied tool to reseat the Switcher board in the
8150 Signal Chassis.
STEP 4: Power up the Signal Chassis. Perform wipes on the M/E and
PGM/PST buses to verify proper operation. Select the
SuperMatte generator as a source and adjust it to verify that
it is present.
Color Corrector/Color Corrector Bypass
Before proceeding, ensure that you have the correct sub-board; the Color
Corrector board is Accom P/N 9400-0648; the Color Corrector Bypass
board is Accom P/N 9400-0731. Figure 3-13 shows the major
components on both sub-boards and their assembly numbers for
identification.
WARNING: Removing the Switcher board
disconnects the RAM battery backup. Save all
effects, timelines, personality files, and
engineering setups to disk before extracting the
board.
Figure 3-13 CCR Bypass (Left) & CCR (Right) Sub-Boards
8150 Technical Guide Option Installation
9100-0212-04 - May 2000
Option Installation
3-21