Installation guide

The advanced screen is for factory use only. You should not make any adjustments to any of the information on this screen.
These setting should not be modified unless directed by an Acclima technician.
Configure Devices
All devices installed on the system are displayed by category. This includes moisture sensors, zone adapters, flow meters,
pressure meters, and water sources. After a device is configured it can be assigned to a zone. You may Add, Remove and Replace
devices from this menu. You may also view and modify the configuration of any.
Install, Remove and Replace System Devices
Once a device is physically installed in or removed from the irrigation system on your site, it must also be installed/removed
in the software. Be sure not to change configurations on the software without first making the changes on the controller
and vice versa. Devices can be reconfigured if you have made errors or wish to change the controller’s configuration.
To install a moisture sensor or zone adapter
1. Click the “Install System Devices” button.
2. Enter the serial number of the device and click “Detect By Serial Number”. Serial numbers are inscribed on the
device. Zone adapters contain many serial numbers (see the CS3500 installation guide for details).
To add a water source
1. Click the “Install System Devices” button.
2. Click the “Add Water Source” button.