Instructions / Assembly

3
1
.Remove
the existing
3.Route
the light control’s
wires through
the
large
gasket
holes.
4.Twist
the junction box wires and
wires
together
as
shown.
Secure
with
wire
connectors.
White to
White
Black to
Black
Junction box ground wire to
green ground screw on
xture.
Gasket
Mounting
Strap
Mounting
Bolt
Rubber
Plug
Install the Light
1.Align
the light
control cover
plate
and
plate
gasket. Secure with
the mounting bolt.
4 To
avoid
water damage and
electrical
shock,
keep
heads
holders
below horizontal.
5.Adjust the heads by loosening the lock
nuts but do not rotate the heads more than
180°from the factory setting.When screwing
in the heads,do not overtighten.
Keep
heads
at least
1" (25 mm) from the
sensor. Do
not
allow
the
sdaeh
to block
the lens.
3.If a
wet
location
junction
box
was not
used,
caulk
the wall plate
mounting
surface
with
silicone
sealant.
Wire the Light Control
WARNING: Turn power off at circuit breaker
or fuse.
fixture.
fixture
light
2.Install the mounting strap as shown using
two screws that fit your junction box.
cover
Lock Nut
Lens
40 ft.
(12 m)
8 ft.
(2.4 m)
Maximum Range
Maximum
Coverage Angle
Bottom of Sensor
Avoid aiming the control at:
• Objects that change temperature rapidly,
such
as heating vents and air conditioners.
These
heat
sources could cause false
triggering.
•
1. Turn on the circuit breaker and light switch.
NOTE: Sensor
has
a 40
second
warm up period
before it
will
detect
motion. When
turned
on, wait
1
minute.
2.Turn
the RANGE control to the medium position
(halfway between MIN and MAX),
and the
ON-TIME control to the
TEST
position.
first
A
reas where pets or traffic may trigger
the control.
.Nearby large,light-colored objects reflecting
light may trigger the shut-off feature.Do not
point other lights at the sensor
MAX
MIN
RANGE
ON
-TIME
TEST
1
5
MINUTES
180°
Test and Adjustment
NOTE:
If fixture is mounted higher than 8 ft.(2.4m).
aiming the sensor down will reduce coverage distance
3.Loosen
the
clamp screw in
the
sensor
ball joint and gently
rotate
the
sensor
.
4.Walk
through
the coverage
area
noting where
you
are
when
the lights
turn
on
head
up
d
own, or
sideways
to
change
the
coverage
area.
Keep
the
sensor
at
least
1"
(25 mm)
away from
the bulbs.
5.Adjust
the
RANGE
as needed. RANGE set
too
high may
increase
false
triggering.
6.
Secure
the
sensor head
by
tightening the
clamp screw.
Do
not
overtighten the
screw.
7.
Set
the amount of
TIME
you
want the lights to
stay
on
after
motion
is detected
(1
or
5
minutes).
Clamp
Screw
Ball
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
Least Sensitive
Most Sensitive
WARNING - Risk
of
re.
Do not aim the heads
at a combustible surface within 3 ft. (1 m).
The detector is less sensitive to motion coming
directly at it
(also ,the LED will flash
several times when motion
is detected).
Motion
Motion
Sensor
Move the sensor
2.Push the rubber plug firmly into place.