Instructions / Assembly

Motion Sensor Light Control
• Turns on
lighting
when motion is
detected.
•
Automatically turns lighting off.
•
Photocell keeps the lighting off during
daylight
hours.
This package includes:
Light Control
Sensor
Cover
Plate
Gas ket
2 Scr ews
Mounting St rap
Mounting Bolt
2 Wire
Connectors
Requirements
•The light
control
requires 120-volts
AC.
•
be wired through a switch.
• Some
codes re quire in stallati on
by
a
qualified
electrician.
• This product is
intended for use with
the enclosed
gasket and with
a junction box
marked for use in
locations.
If you want to use Manual Mode,the control must
wet
Set
the switch
on
the bottom of the
sensor to
TEST.
MANUAL MODE
... back on.
1 Second
OFF then...
* resets to Auto Mode at dawn.
TEST
TEST
1 5 MIN
AUTO
TEST 1 5 MIN
Set switch to
1 or 5 minutes.
Manual mode only works at
night
because
daylight
re
-
turns the sensor to AUTO.
Flip the light switch off
for one second then back
on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with
the ON-TIME switch in the 1,
or 5 position.
Mode: On-Time Works: Day Night
Test
10 Seconds x x
Auto
1 or 5 Min
x
Manual
To Dawn*
x
Note:
When
first
turned on wait about
40
seconds for the circuitry to calibrate.
Questions or problems?
Before
to your retailer, refer to
guide in this manual
troubleshooting
returning
the
Model: LFL2WHM/LFL2ABZM
Rubber
Plug
2
Features
Move switch to
1 or 5 minutes
Mode Switc
Installation
h Summary
off f
or one second
then ba ck on
MANUAL MODE
AUTO
TEST
If
you
get
confused
while
s witching
modes,
turn
the
power off f or
one minute ,
then
bac k
on.
After the cali bration
time
the
control
will
be
in
the
AUTO
mode.
Flip light switch
For easy installation,
select
an
existing
light
with
a w
all
switch for
replacement.
For eave mount
only:
1.
S
wing the
sensor
head towards the
c
lamp screw
joint.
2. Then
rotate
the
sensor
head
clockwise
180°
so
the
controls face
down.
Controls
Wall Mount
Eave Mount
For under eave installation, the sensor head
must
be rotated
as shown
in
the next two steps for
proper
operation
and to avoid the
risk
of
electrical
shoc
k.
Clamp Screw
For best performance,mount the fixture about
8 ft(2 .4m) above the ground.NOTE:If fixture
is mounted higher than 8 ft.(2.4m),aiming the
sensor down will reduce coverage distance.
If the sensor pops out of the ball joint,loosen
the clamp screw and push the sensor back into
the ball joint.Tighten the clamp screw when done.
Controls
Operation