Instruction manual

- 7 -
Connection
Operating with Nano G3
— Take out the sponge stickers for the Nano
G3. Detach the sponge and the white paper.
Then, stick them on the corresponding
position of the speaker.
— Ensure Nano G3 is fully and properly
inserted in the port of the speaker. And push
the frame of the speaker in place. Play your
favorite music by operating the Nano G3.
Connecting with Power Adapter
— Connect the GO GROOVE MOVE to the power source with the provided power adapter.
Insert the AC plug into your local power supply / wall outlet, and the other end into the DC
input jack
on the back of the GO GROOVE MOVE.
Note: If not using the provided power adapter, check the operating voltage indicated on the
adapter and polarity is identical with the voltage of your local power supply and the speaker. If
not, it will damage the speaker or iPhone.
Connecting with other devices
— You can play music by using the included 3.5MM to 3.5MM cable to connect the “INPUT”
port on the back of the GO GROOVE MOVE, with other audio source devices, such as
iPod, MP3 or PC/Laptop etc.
Note: 1. When inserting the 3.5MM cable, the iPhone audio will be stopped, but the iPhone
will still be in operating/charging mode.
2. Turn down the volume if there is distortion. (Because different audio output the electrical
level varies.)