Owner`s manual

AccessLine Communications

Owner’s Manual AccessLine 8-23-11

Resetting the Cordless Transmitter

In order for your Cordless Phones to register with the Cordless

Transmitter, when you first install a new Cordless Phone you must

press the RESET button on the rear of the Cordless Transmitter.

Once your phone is registered you should not need to repeat this

procedure.

Each time you reset the Cordless Transmitter, the Cordless Phones

will re-register. Make sure Cordless Phones are within range of the

Cordless Transmitter to register properly.

To reset the CORDLESS TRANSMITTER:

Momentarily press and release the RESET button on the

rear of the CORDLESS TRANSMITTER (do not hold it

down).

On the front of the CORDLESS TRANSMITTER, the

POWER light will remain on steadily during a reset and the

I-NET light will flash and the VoIP light will go out.

After a few minutes when the reset is complete the I-NET

light will remain on steadily, and the VoIP light will come

back on, indicating the CORDLESS TRANSMITTER is

ready to use.

Note: Check to be sure all Cordless Phones are registered (or

reconnected) properly with the CORDLESS TRANSMITTER after

the reset is complete.

4 Administrator Functions

The Administrator has the ability to make configuration changes to

phones and other pieces of equipment. Some changes can be

made through the phone, but most changes and capabilities are

accessed through the Admin Portal.

Making Changes through a Desk Phone