Owner`s manual

AccessLine Communications
Owner’s Manual AccessLine 8-23-11
66
section describes the function of the lights on the Cordless
Transmitter and some of the initial phone startup screens.
Cordless Transmitter Basics
The Cordless Transmitter provides wireless connectivity to the
Cordless Phones. The Lights on the front of the Cordless
Transmitter indicate the current status. After the initial installation
and activation, the POWER and I-NET and VOIP lights should
remain lit.
The following describes the indicator lights, ports and buttons on the
Cordless Transmitter which, in turn, provides information on the
operating state.
Label
Description
POWER
Remains lit when the power is on.
I-NET
Remains lit when the Cordless
Transmitter has an IP address and has
been connected to the AccessLine
Network. Flashes during boot.
VOIP
Remains lit when the Cordless
Transmitter is connected to the
AccessLine Network
CALL
Remains lit when a call is in progress
RESET
(back of unit)
Press momentarily to reboot the unit,
activate configuration changes, and
enable Cordless Phone registration
mode.
Press and hold 15 seconds to reboot
with factory default settings. All front
panel lights come on when a factory
restart is initiated.
NOTE: Any custom configuration
settings are lost during a factory
default.
DC 9-20V
(back of unit)
Indicates where the power plug
connects
LAN
(back of unit)
Indicates where the Ethernet cable
connects (the other end of the
Ethernet cable connects to either the
Base Unit or your router or switch)