Owner`s manual

AccessLine Communications
Owner’s Manual AccessLine 8-23-11
28
Step D Seat the U-type leg (3) onto the big U-type frame (4) at
about a 30º-angle position.
-Or-
Step E Pull-in the U-type leg (3) and seat it at about a 45º-angle
position in the big U-type frame (4).
-Or-
Step F Pull-in the U-type leg (3) and seat it at about 60º-angle
position in the big U-type frame (4).
Wall-mounting a Desk Phone
The IP phone can be used on the desktop or mounted on a wall.
Print the screw alignment template (on the next page) and tape it on
the wall to position the 3 screws provided at the right place for the
mount-holes on the phone.
Before mounting the IP phone to the wall, detach the handset and
curled cord from the IP phone, then perform the following steps:
Step A On the back of the phone, find the latch (3) on the U-type leg
and remove it.
Step B Remove the other latch (4).
Step C Remove the U-type leg (1). Retain the leg (1) and latches
(2) for possible reuse in a desktop mode.
Step D Seat the big U-type frame onto the back of IP phone.
Step E Re-check that the power source switch is in the correct
position.