Owner`s manual

AccessLine Communications
Owner’s Manual AccessLine 8-23-11
27
3. Connect Power to the Desk Phone
Use the included power cord and plug one end into the back of the
phone and the other end into the wall outlet. The phone will indicate
that it is configuring itself. Once the phone has finished its
configuration, it is ready to make and receive phone calls.
Note
To the right of the power plug is a switch marked Power Source.
The switch position must be set to Adapter. POE is not
supported.
Setting up the Stand
To setup the stand for the Desk Phone, refer to the following steps
and the associated illustration to setup the stand of the Desk phone.
Step A Move the big U-type frame (4) downward.
Step B Move the big U-type frame (4) downward to the flat level.
The small U-type frame (5) will get flat concurrently.
Step C Move the U-type leg (3) upward.