User Manual

CONFIG MENU PARAMETER
Cong Menu Parameters
This menu is opened by pressing the CONFIG button to the left of the display. It contains global parameters
that determine how the entire Virus works. Conguration data does not have to be explicitly stored.
MIDI
Global  Channel
1 to 16: Species a MIDI channel used for SINGLE mode, as well as for switching between MULTI mode
programs via the MIDI message “Program Change”.
Soft  Thru
Off, On: Species whether received MIDI data is also directly routed to (i.e. mirrored at) the MIDI out socket.
Before switching this parameter on, make sure there will be no MIDI loop in your system. This parameter has
no effect when working with Virus Control.
 MIDI Device ID
1 to 16, Omni (17): Identication number for transmitting/receiving System Exclusive data (see glossary). To
allow SysEx communication between two devices, they must be set to the same device ID. If set to Omni,
the Virus will receive Sysex data with any ID, and transmit with ID = 17.
Arp Note Send 
Off, On: Species whether the notes created by the arpeggiator will be sent to the MIDI output instead of the
original played notes.
MIDI Volume 
Disabled, Enabled: Species whether MIDI CC#7 (volume) will be recognized.
 Program Change
Disabled, Enabled: Species whether the MIDI message “Program Change” will switch Single programs. This
applies to programs in Single mode as well as PARTs in Multi or sequencer mode.