User Manual

PARAMETER REFERENCE MANUAL62
Mix •
Off, 1 to 127: Cross-fade between the dry and wet signal. Set this to 64 for normal phasing (together with
zero Feedback - see below).
Modulation destination “Phaser Mix“.
Frequency •
0 to 127: The average frequency of resonant peaks (see Spread below). Modulation destination “Phaser Fre-
quency“.
Feedback •
-64 to +63: The amount of signal fed back into the Phaser input, causing a resonance effect. The Feedback
parameter is bipolar because positive and negative values result in different tonal characteristics.
Modulation destination “Phaser Feedback“.
Mod Rate •
0 to 127: Modulation rate - the speed of the Phaser’s dedicated LFO (a triangle wave) used to modulate the
Frequency parameter (see above).
Modulation destination “Phaser Mod Rate“.
Mod Depth •
0 to 127: How much the Frequency parameter (see above) is modulated by the Phaser’s LFO.
Modulation destination “Phaser Mod Depth“.
Stages •
1 to 6: The number of all-pass lters used in the Phaser. This value affects the complexity of the phased sig-
nal.
Spread •
0 to 127: How far apart the resonant peaks between multiple stages are. Modulation destination
“Phaser Spread“.
Vocoder
Although available as “effect”, the Virus Vocoder actually replaces the entire lter section i.e. Vocoder and
normal lters cannot be used at the same time within a single program.