User Manual

EFFECT PARAMETER
Mix •
Off, 1 to 127: Cross-fade between the dry and wet signal. Set this to 64 for maximum Chorus, or to 127 for
a vibrato effects. If set to Off, none of the other parameters in this menu will be visible.
Modulation destination “Chorus Mix“.
Delay •
0 to 127: The nominal delay time, modulated by a dedicated LFO (see “Mod Rate” etc. below). Very high
values result in a short but noticable stereo delay effect.
Modulation destination “Chorus Delay“.
Feedback •
-64 to +63: The amount of signal fed back into the Chorus input. The Feedback parameter is bipolar be-
cause positive and negative values have different tonal characteristics.
Modulation destination “Chorus Feedback“.
Mod Rate •
0 to 127: Modulation rate - the speed of the dedicated LFO.
Modulation destination “Chorus Mod Rate”.
Mod Depth •
0 to 127: How much the LFO modulates the Delay parameter.
Modulation destination “Chorus Mod Depth“.
Mod Shape •
Sine, Triangle, Sawtooth, Square, S&H, S&G: Selects the waveform used to modulate the Delay parameter.
Phaser
Typically, phasing is the classic “whoosh” effect originally achieved by running two tape machines in parallel,
then slightly changing the speed of one of them. The Virus phaser uses up to six “all-pass” lters to achieve
a very similar effect. In combination with Feedback, the Virus phaser is also capable of resonator, ensemble,
vibrato and anging effects. Note that if the Mix parameter is set to Off, the other parameters will not be vis-
ible in the menu.