User Manual

PARAMETER REFERENCE MANUAL58
Pre • delay
0.0 ms to 300.4 ms: The time between the original signal and the reverb signal, expressed in milliseconds.
This can be fed back for multiple reverb tails.
Modulation destination “Reverb Predelay“.Only visible if the Clock parameter is set to Off (see above).
Feed • back
0 to 127: How much of the reverb signal is fed back into it’s own input. The repeat rate is determined by the
Predelay parameter (see “Predelay” above).
Modulation destination “Reverb Feedback”. Only visible in Feedback 1 or Feedback 2 modes.
Low EQ
Frequency •
32 to 458: Low shelf (1 pole) cutoff frequency in Hertz.
Gain •
-16 dB to +16 dB: Low shelf cut or boost.
Mid EQ
Frequency •
19 Hz to 24.0 kHz: Centre frequency of the MID EQ. Values above 10,000 are given in kHz.
Modulation destination “EQ Mid Frequency”.
Q-Factor •
0.28 to 15.4: Bandwidth around the centre frequency. Low values are wider, high values are narrower. For
wah-wah effects, set very high Q-Factor and Gain values, then modulate “EQ Mid Frequency”.
Modulation destination “EQ Mid Q-Factor”.