User Manual

EFFECT PARAMETER
Mode •
Value Meaning
Off No effect. All other parameters will not be visible.
Reverb tandard reverb effect with predelay (see “Predelay” parameter below).
Feedback 1 Reverb effect with a feedback loop in the pre-delay line, thus allowing multiple reverb tails.
Feedback 2 The same as Feedback 1, except that the rst reverb tail appears immediately.
Type •
Ambience, Small Room, Large Room, Hall: Different types of room simulations, in order of size. This param-
eter affects the so-called “early reections”.
Send •
Dry, 1 to 126, Wet: Effect send. Actually a cross-fade between dry and wet - the overall level remains fairly
constant.
Modulation destination “Reverb Send”.
Clock •
Off, 1/64 ... 3/4: Used to synchronize Predelay to the Clock (see “Predelay” below). Expressed as a 4/4 bar
division.
• Time
0 to 127: The length of the reverb tail. Modulation destination “Reverb Time”.
Dam • ping
0 to 127: For simulating different surface materials by progressively removing higher frequencies. Carpets
and drapes etc. tend to absorb a lot of high frequencies, while tiled oors and walls do not.
Modulation destination “Reverb Damping”.
• Coloration
-64 to +63: Post-EQ for the reverb signal. Negative values are mellower, positive values are brighter.
Modulation destination “Reverb Coloration”.