User Manual

OCILLATOR
Value The waveform of oscillator 3
lave Oscillator 3 will follow oscillator 2. The mixture of waveforms i.e. HAPE and any modulation
applied to oscillator 2 will also apply to oscillator 3. The values of “emitone” and “Detune” (see
below) are ignored.
aw, Pulse,
ine, Triangle,
Wave 3 to
Wave 64
Oscillator3 waveform. Note that if “Pulse” is selected here, its pulse width will follow that of
oscillator 2.
Semitone •
-48 to +48: The pitch of oscillator 3. If Slave mode is selected, this value will be ignored and oscillator 3 pitch
will track oscillator 2 pitch.
Modulation destination “Osc3 Pitch“.
Volume •
0 to 127: The level of oscillator 3 when switched on. See “Mode/Wave” above.
Modulation destination “Osc3 Volume”.
Detune •
0 to -127: Fine-tunes oscillator 3 downwards. Ignored if Slave mode (see “Mode/ Wave” above) is selected.
Modulation destination “Osc3 Detune“.
Oscillator 2 (Simple Grain Table)
Mode •
Classic, HyperSaw, WaveTable etc.: Selects the basic type of oscillator.
Index •
Determines the playback position within the currently selected Wavetable. Each of the 128 available values
represents either a particular wave or the interpolation of the two nearest waves. Modulating the Index of a
wavetable with an LFO or Envelope will often result in a highly-dynamic variation in the timbre of a sound,
impossible via any other means.