User Manual

PARAMETER REFERENCE MANUAL12
Balance •
-64 to +63: Adjusts the relative levels of oscillator 1 and oscillator 2 (including FM), whereby -64 is oscilla-
tor 1 only and +63 is oscillator 2 only. Note that this parameter is mirrored in the oscillator 2 menu. Modula-
tion destination “Osc Balance”.
Oscillator 1 (HyperSaw)
This information only applies to oscillator 1 in HyperSaw mode
Mode •
Classic, HyperSaw, WaveTable etc.: Selects the basic type of oscillator.
Density •
1.0 to 9.0: The number of sawtooth waves used. The volumes are cross-faded for completely smooth tran-
sitions. Modulation destination “Osc1 Shape“.
Spread •
0 to 127: Detuning of individual sawtooth waves within the HyperSaw. Modulation destination “Osc1
PulseWidth”.
Semitone •
-48 to +48 semitones: Adjust the pitch of oscillator 1 in semitones. Modulation destination “Osc1Pitch“.
Key Follow •
-64 to +31, Norm, +33 to +63: How much the pitch of oscillator 1 follows the keyboard (i.e. MIDI note
number). Press both VALUE buttons at the same time for normal tuning (Norm).
Balance •
-64 to +63: Adjusts the relative levels of oscillator 1 and oscillator 2 (including FM), whereby -64 is oscilla-
tor 1 only and +63 is oscillator 2 only. Note that this parameter is mirrored in the oscillator 2 menu. Modula-
tion destination “Osc Balance”.
Sync •
Off, On: Switches oscillator 1 Sync off/on.
Unlike Classic oscillators where oscillator 2 can be synchronized to oscillator 1, HyperSaws are always syn-
chronized to their own internal sync oscillator. In HyperSaw mode, FM Amount controls a frequency offset