Specifications

EDITPAGES
You can adjust the following 3 parameters via the Value knobs beneath the display:
SoftKnob Parameter Meaning
#1 LFO1Rateor
Clock1
SelectpatchRAMA-64‘Tutorial5’andlistencarefullytothesoundasyou
adjustthisparameter.Inthispatch,LFO1ismodulatingtheamountoflter
resonance.
#2 LFO2Rateor
Clock2
Listencarefullytothesoundasyouadjustthisparameter.Inthispatch,
LFO2ismodulatingthestereopositioningofthesound,or‘panorama’.
#3 LFO3Rateor
Clock3
Listencarefullytothesoundasyouadjustthisparameter.Inthispatch,
LFO3ismodulatingthepitchofbothoscillators.
Envelopes Menu
Please select patch “Tutorial 6” (RAM8 8-6). This is where you can determine the overall shape of a sound,
both in volume and timbre. The value knobs are assigned as follows:
SoftKnob Parameter Meaning
#1 AmpAttack Thisdetermineshowlongittakesforthesoundtoreachfullvolumeaftera
keyispressed.Thehigherthevalue,thelongerittakes.
#2 FilterAttack Thisdetermineshowlongittakesfortheltertoreachthemaximumvalue
asdeterminedbythecurrentsettingforCutoff1or2(Offset),coupledwith
theFilterEnv1/2Amountvalue.NoeffectwillbeheardhereunlessFilter
1/2EnvAmtissettoavalueotherthanzero.
#3 FilterEnvAmt Thisdeterminesthedegreetowhichthelterenvelopewillaffectthecutoff
ofthelters.Forthistohaveanyaudibleeffect,youwillneedtoturnthe
Cutoffknobdown-avalueofaround30shouldbesuitable.Now,keep
playingnotesasyougraduallyincreasethevalueofEnvAmount.Notice
howthebeginningofthenotes(theattack)getssharperandbrighter,
thehigherthevalueofEnvAmount?That’sbecausethelterenvelopeis
sweepingthecutoffrightup,thenrightdownagainatthestartofevery
note(thisiswhyyouneededtoturnCutoffdown,sothattheenvelopehad
somewheretogo).
Effects Menu
Please select patch “Tutorial 7” (RAM8 8-7).
Enter the Effects menu. Effects are used for further processing of the entire output of the synth engine. You
can adjust 3 parameters relevant to the current patch via the Value knobs beneath the display: