Specifications

66
LFO 3
The controls in this section are used to affect the characteristics of
LFO 3, and determine which parameter(s) it will modulate. Many
parameters are identical in function to their equivalents in LFOs 1and
2.
NOTE: Note: the functionality of LFO 3 is not the same as that of
LFO 1 and 2. This LFO is designed for creating vibrato effects, and as
such only has one destination slot.
NOTE: Tip: If you want LFO 3 to modulate other parameters, you can
choose it as a Source in the Mod Matrix (See ModMatrix page).
> RATE
This determines how fast LFO 3 will oscillate. The higher the value,
the faster it will oscillate.
> CLOCK
This overrides Rate and forces LFO 3 to sync its wave cycle to the clock control. The frac-
tions are relative to a whole note, or semibreve, which in turn are equivalent to a whole bar/
measure in 4/4 time. So, by choosing a clock rate of 1/4, LFO 3 will sync to a quarter note
(crotchet) cycle, whereas a setting of 4/1 will cause it to sync to cycle of 4 bars.
> SHAPE
This determines the waveform of LFO 3 - different waves can result in very different modula-
tion effects. Choose between the following options:
>Sine: A smooth up/down cyclic wave.
>Triangle: Similar to sine wave, but with sharper peaks and a linear curve.
>Sawtooth : This will cause the sound to rise/fall, then jump back suddenly to rise/
fall again.
>Square: Use this to jump back and forth between two values.
indigo powercore manual.book Page 66 Thursday, April 22, 2004 12:23 PM