Specifications

46
NOTE: If the filters are in Split Mode, then Pan Spread will also affect the stereo separation of
the signals from filter 1 and 2.
> LFO PHASE*
This determines the phase offset between the LFOs in each voice. At extreme settings, the
LFOs of Voice 1 will modulate in opposite phase to the LFOs of Voice 2, resulting in a much
busier sound.
NOTE: *This parameter will have no effect if Unison Mode is Off.
Mixer
Here you will find the controls
for balancing the different
sound sources within the
oscillator section.
> OSC 1/2 BAL
This adjusts the balance between osc1 and osc 2. At –64 you will hear only osc 1, and at +63
only osc 2. At +0 (default) both oscillators are equally balanced.
> OSC 3 VOL
This adjusts the volume of oscillator 3. At a setting of 0, osc 3 will be inaudible (but still active,
so if you don’t intend to hear it at all, better switch it off and free up some polyphony!). To bal-
ance it evenly with osc 1 and 2, try setting Osc 3 Vol to 64.
NOTE: This parameter will have no effect if Osc 3 > Osc Mode is set to Off.
> SUB VOL
This adjusts the volume of the sub-oscillator, which is used to make the sound fuller and
deeper by adding an extra tone at a pitch of one octave below osc 1.
indigo powercore manual.book Page 46 Thursday, April 22, 2004 12:23 PM