Specifications

104
CONTROL CHANGE MESSAGE (ONLY PAGE A)
The Control Change messages are defined as Performance Controller (e.g. Modulation Wheel or
Hold Pedal) or Sound Parameters (e.g. Cutoff or Patch Volume). The Performance Controllers are
not stored with a Single-Sound. If more than one Multi Part is set to the same MIDI channel, all Parts
on this MIDI channel receive the same Performance Controllers. The Sound Parameters are stored
with a Single Sound. If more than one Multi Part is set to the same MIDI channel, the Sound Param-
eter is receiced only by the Multi Part with the lowest part number.
Example: B0,21,40 Set oscillator balance (21 hex = 33 dec) on MIDI channel 1 to the middle position
(40 hex =64 dec).
POLYPHONIC PRESSURE MESSAGE (ONLY PAGE B)
Example: A2,07,25 Control LFO3 Rate on MIDI channel 3 (!).
Byte Meaning Remark
Bc Status byte c=MIDI channel
nn Parameter Number 0..127 see parameter list Page A)
vv Parameter Value 0..127 see parameter list Page A)
Byte Meaning Remark
Ac Status byte c=MIDI channel
nn Parameter Number 0..127 see parameter list Page B
vv Parameter Value 0..127 see parameter list Page B
indigo powercore manual.book Page 104 Thursday, April 22, 2004 12:23 PM