User Manual

OCILLATOR
Sub Oscillator
An extra “slave” oscillator tuned an octave below its master oscillator. If oscillator 1 is in Classic mode, the
sub-oscillator is a Square or Triangle wave slaved to oscillator 1. If either oscillator 1 or 2 is in HyperSaw
mode, the sub oscillator is HyperSub instead
Volume •
0 to 127: Sub oscillator mix. In HyperSaw mode, this parameter crossfades between HyperSaw and Hyper-
Sub.
Modulation destination “SubOscVolume“.
Shape •
Square, Triangle: Selects the sub oscillator waveform.
Not available if oscillator 1 is in HyperSaw or WaveTable mode.
Noise
Volume •
Off, 1 to 127: The level of noise. If set to Off, the Color parameter will not be visible.
Modulation destination “Osc Noise Vol“.
Color •
-64 to +63: Adjusts the noise frequency range. Negative values are darker, positive ones are brighter. A value
of 0 is standard “white noise”.
Modulation destination “Osc Noise Color“.
Ring Modulator
The Ring Modulator creates additional frequencies (the sum and difference) by multiplying the oscillator 1
and 2 signals. It cannot be active in Split Mode.