Installation Guide

CERTIFICATION: UL DRY NO. 72002LEDD

CONNECT THE WIRES

Option A - For use without the cord

Connect the black supply wire to the black fixture wire.

Secure with the supplied wire nuts. Connect the white

supply wires to the white fixture wire. Secure with the

supplied wire nuts. Either wrap the green wire around

one of the protruding screws or connect it to the supply

ground wire. Secure all wires with U.L. Certified

electrical tape (not supplied).

Option B - For use with the cord

Thread the open screw (1) onto the supplied cord. Gently

feed the cord through the opening in the lower end of

the fixture base (2). Continue to pull the cord through

opening (3). Follow the same wire connection procedure

as with option A.

MOUNT THE BACKPLATE

Fit the fixture base up to the mounting plate. Align the

slot at the top of the plate with the pin on the top of the

base.

Ensure that the holes at the bottom of the base and plate

are aligned. Secure with supplied screw nut at bottom.

PLUG-IN TO THE SOCKET

RESTORE THE ELECTRICITY AND

CHECK THE OPERATION OF YOUR

NEW ACCESS LIGHTING FIXTURE

If the fixture is to be removed or replaced,

please ensure that the electricity is

switched off and that the fitting is cool

before touching it.

CAUTION

Option A - use without the cord

Option B- use with the cord

Open screw

(1)

xture

base

Opening

(3)

Opening (2)

mounting

plate

mounting

plate

xture

base