Installation Sheet
(4) PREPARE THE FIXTURE
1. If you are replacing an existing fixture, disconnect and remove
the old fixture. Expose the supply wiring from the outlet box.
2. Lay the un-assembled fixture on a soft surface and carefully
remove all the packing material.
3. Locate the Metal Collar, just below the Canopy and unscrew it
allowing the Canopy to slide down the Coaxial Cable.
4. Locate the Strain Relief. Loosen the Strain Relief and Wire
Nuts so that the Coaxial Cable is released.
5. Determine the desired length of your fixture. Cut the Coaxial
Cable to the desired length, leaving +/- ½” to make the
necessary power connections.
6. Slide the wire through the hole located at the top of a Glass
Shade.
7. Feed the Coaxial Cable through the Strain Relief and tighten
the screw to ensure that the Coaxial Cable is secure. Using
the supplied Wire Nuts connect the Coaxial Cable to the
Driver Wires.
8. Feed the Black and White Driver Wires (AC Input Wires)
through the designated Hole in the Back Plate. Attach the
Supply Wires to the Fixture Wires in the following manner:
The Black supply wire attaches to the Black fixture wire and
the White supply wire attaches to the White fixture wire.
Secure these connections with supplied Wire Nuts and tape
these connections with U.L Listed electrical tape.
9. Tuck all of the wires into the Junction Box.
10. Secure the Base Plate to the Junction Box with the supplied
Screws. Hold the Canopy up to the Base Plate and secure
with the Metal Collar.
11. Restore electricity and enjoy your new lighting fixture.
CAUTION:
Do not install this fixture closer than 6” from any
curtain or combustible material.
Do not install fixture in hazardous locations
Ensure that this fixture is cool before touching or
adjusting
***READ & SAVE THESE INSTRUCTIONS ***
ACCESS LIGHTING
MODEL 70012LED
INSTALLATION & OPERATION INSTRUCTIONS
1) TOOLS AND MATERIALS REQUIRED
Blade Screwdriver
Star Screwdriver
Wire Cutters
Wiring supplies as required by Electrical Code
Step Ladder
Glass Shade (see available options in catalog)
Attention:
Before assembling your lighting fixture, please
read the following instructions.
(2) GENERAL
1. To ensure the success of the installation, be sure to read these
instructions thoroughly before beginning.
2. All electrical connections must be in accordance with local
codes, ordinances, or the National Electrical Code. If you are
unfamiliar with methods of installing electrical wiring, secure the
services of a qualified licensed electrician.
3. These fixtures are intended for mounting to a standard 4” x 2 ¼”
deep metal octagon outlet box. The box must be directly
supported by the building structure and U.L. Recognized.
4. Before commencing with the installation, disconnect the power
by turning off the circuit breaker or by removing the fuse at
the fuse box. Turning the power off using the light switch is not
sufficient to prevent electrical shock.
NOTE:
The important safeguards and instructions appearing in
this manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense, caution and care, are
factors that cannot be built into any product. The
person(s) caring for and operating the fixture must
supply these factors.
(3) UNPACKING THE FIXTURE
On checking the contents of the box you will find;
1. Base Plate
2. Hardware Packet
3. Canopy
4. Strain Relief
5. Metal Collar
6. 1 x 5W Super White LED (4500K) with LED driver
a c c e s s
L I G H T I N GG
G G
072109IPV1