Installation Sheet

2
4
2
CERTIFICATION: ETL DRY NO. 63957LEDD
3
MAKE WIRE CONNECTIONS
Mount the crossbar to the J-box with the supplied screws.
Gently pull the supply wires through the hole in the
crossbar. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nut.
Connect the white supply wire to the white fixture wire.
Secure with the supplied wire nut. Either wrap the green
wire around one of the protruding screws or connect it to
the supply ground wire. Secure all wires with electrical
tape (not supplied).
Tuck all wires carefully into the J-Box
MOUNT THE CANOPY AND INSTALL
GLASS SHADES
Hold the canopy up to the crossbar.
Align the centre hole of the canopy and secure with
the supplied screw knob.
Install the glass shades over the LED module by sliding
one side of the glass shade and then the other side,
gently under the clips.
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION