Installation Guide

1
WHAT YOU NEED
•
Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
2
4
2
CERTIFICATION: cULus DAMP NO. 63125LEDDLP
3
MOUNT CROSSBAR AND MAKE WIRE
CONNECTION
If there is an existing fixture remove it.
Install the crossbar and mount it to the J-Box with
the supplied screws. Expose the supply wires from the
J-box. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts.
Connect the white supply wire to the white fixture wire.
Secure with the supplied wire nuts. Attach the green
J-Box wire around green hexagonal head screw or
connect it to the green supply grounding wire of the
fixture. Secure all wires with electrical tape
(not supplied). Tuck all wires carefully into the J-Box.
MOUNT THE CANOPY
Fit the canopy up to the crossbar. Align the holes
of the canopy and secure with the supplied screw
knobs.
INSERT THE BULB AND GLASS SHADE
Insert the bulb.
DO NOT EXCEED THE MAXIMUM WATTAGE AS
STATED ON THE WARNING LABEL
Place the glass shade over the socket. Align the holes
of the glass shade and secure with the supplied screws.
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that exceed the
maximum wattage, stated on caution label.
CAUTION
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
VER: 18.12.1