Installation Guide

1
WHAT YOU NEED
•
Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
2
4
2
CERTIFICATION: cULus DRY NO. 63121LEDDLP
3
MOUNT CROSSBAR AND MAKE WIRE
CONNECTION
If there is an existing fixture remove it.
Install the crossbar and mount it to the J-Box with
the supplied screws. Expose the supply wires from the
J-box. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts.
Connect the white supply wire to the white fixture wire.
Secure with the supplied wire nuts. Attach the green
J-Box wire around green hexagonal head screw or
connect it to the green supply grounding wire of the
fixture. Secure all wires with electrical tape
(not supplied). Tuck all wires carefully into the J-Box.
MOUNT THE CANOPY
Adjust the length of fixture and secure with the
supplied strain relief screw.
Fit the canopy up to the crossbar. Align the holes of
the canopy and secure with the supplied screw
knobs.
INSERT THE BULB AND GLASS BAR
Insert the bulbs.
DO NOT EXCEED THE MAXIMUM WATTAGE AS
STATED ON THE WARNING LABEL
Fit the glass bar to the centre ball and screw up.
If the glass bar is dirty, polish it with wet cotton cloth,
don’t use any chemical liquid or solvent.
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that exceed the
maximum wattage, stated on caution label.
CAUTION
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
VER: 18.12.1