Installation Guide

2
4
2
CERTIFICATION: UL DRY NO. 63065LEDD
3
MAKE WIRE CONNECTIONS WITH DRIVER
Mount the crossbar to the J-box with the supplied screws.
Gently pull the supply wires through the hole in the
crossbar. Connect the black supply wire to the black
driver input wire. Secure with the supplied wire nut.
Connect the white supply wire to the white driver
input wire. Secure with the supplied wire nut. Either
wrap the green wire around one of the protruding screws
or connect it to the supply ground wire. Secure all wires
with electrical tape (not supplied).
Tuck all wires carefully into the J-Box
MOUNT THE CANOPY
Hold the canopy up to the crossbar.
Align the holes at the side of the canopy and
secure with the supplied screws.
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION