Installation Sheet

PREPARE FIXTURE
If there is an existing fixture remove it.
Screw all the arms into the threaded holes in the
center balls and secure with allen screws.
MOUNT THE FIXTURE AND MAKE
WIRE CONNECTIONS
Expose the supply wire from the outlet box. Mount the
crossbar to the junction box with the supplied screws
Gently pull the supply wires through the hole in the
crossbar. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts. Connect
the white supply wires to the white fixture wire. Secure
with the supplied wire nuts. Attach the green J-Box
wire around green hexagonal head screw or connect
it to the green supply grounding wire of the fixture.
Secure all wire with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
Adjust the length of fixture by using grip lock.
Position the canopy over the crossbar plate.
Align the holes in the canopy and secure with the
supplied thumb screws.
SECURE THE GLASS SHADES AND INSERT
THE BULBS
Hold the glass shades at a slight angle to the fixture
and fit over the socket spring.
Do not insert shades vertically as the glass may crack.
Insert the supplied bulbs. MAXIMUM WATTAGE 40W.
DO NOT EXCEED THE MAXIMUM WATTAGE AS
STATED ON THE WARNING LABEL AND IN
INSTRUCTION SHEET
1
WHAT YOU NEED
•
Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
2
4
2
CERTIFICATION: cULus DRY NO. 62327
3
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that exceed the
maximum wattage, stated on caution label.
CAUTION
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE