Installation Sheet

ManualsBrandsAccess Lighting ManualsChandeliersAccess Lighting Glam 5 Light 22-13/16" Wide LED Chandelier

IMPORTANT

Before assembling your access lighting fixture, please make sure that

you carefully read through these instruction sheets. Consider having

your fixture installed by a qualified licensed electrician.

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

PREPARE FIXTURE

If there is an existing fixture remove it.

Tighten 3pcs rods to the canopy and fixture.

Expose the supply wire from the outlet box.

Mount the crossbar to the junction box with

the supplied screws

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box

must be directly supported by the building structure and U.L. Recognized.

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

•

Mounting Hardware

• Crossbar Plate

• 5 x Glass and crystal beads

shades

• 3pcs rods, 6”, 16” and 22”

• 5 x 48W Xenon G9 Bulbs

COLLECTION

CERTIFICATION: ETL DRY

NO. 52120

52120

APPLICATION MODEL NO.

Chandelier

GLAM

For energy saving, this fixture is supplied with

48W G9/ER bulbs, which is equivalent to

60W standard G9 Halogen.

Summary of content (3 pages)

PAGE 1
CERTIFICATION: ETL DRY NO. 52120 INSTALLATION INSTRUCTIONS IMPORTANT Before assembling your access lighting fixture, please make sure that you carefully read through these instruction sheets. Consider having your fixture installed by a qualified licensed electrician. NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur.
PAGE 2
CERTIFICATION: ETL DRY NO.52120 MAKE WIRE CONNECTIONS Gently pull the supply wires through the hole in the 2 crossbar. Connect the black supply wire to the black fixture wire. Secure with the supplied wire nuts. Connect the white supply wires to the white fixture wire. Secure with the supplied wire nuts. Either wrap the green wire around one of the protruding screws or connect it to the supply ground wire. Secure all wire with electrical tape (not supplied). Tuck all wires carefully into the J-Box.
PAGE 3
CERTIFICATION: ETL DRY NO. 52120 5 6 3 INSERT THE BULBS Insert the bulbs. MAXIMUM WATTAGE 48W. DO NOT EXCEED THE WATTAGE AS STATED ON THE WARNING LABEL AND IN THE INSTRUCTION SHEETS RESTORE THE ELECTRICITY AND CHECK THE OPERATION OF YOUR NEW ACCESS FIXTURE CAUTION Please ensure that the fitting is cool and switched off before replacing the bulb. DO NOT use bulbs that might exceed the maximum wattage, stated on caution label.