Installation Sheet

(4) PREPARE THE FIXTURE
1. If you are replacing an existing fixture, disconnect and remove
the old fixture. Expose the supply wiring from the outlet box.
2. Lay the un-assembled fixture on a soft surface and carefully
remove all the packing material.
3. Attach the supplied Crossbar to the J- box, with the supplied
Mounting Screws
4. Screw the supplied Nipple into the center of the Crossbar.
Adjust to the required length and secure with the Hex Nut
provided.
5. Attach the Supply Wires to the Fixture Wires in the following
manner: The Black supply wire attaches to the Black fixture
wire and the White supply wire attaches to the White fixture
wire.
6. Attach the Green/Ground wire from the fixture to the Electrical
Supply Wire or to the Green Screw located on the Universal
Crossbar.
7. Secure these connections with supplied Wire Connectors (2)
and tape these connections with U.L Listed electrical tape.
Tuck all of the wires into the Junction Box.
8. Position the Fixture Canopy over the Nipple protruding from the
Crossbar, and secure with the supplied Thumb Nut.
9. Insert the GU-10 Bulbs. DO NOT EXCEED WATTAGE AS
INDICATED ON WARNING LABEL.
10. Insert a Glass Shield into the Metal Ring and place the
complete unit onto the bulb. Secure by snapping the Metal Ring
onto the bulb.
11. Restore electricity and enjoy your new lighting fixture.
CAUTION:
 Ensure that the Fitting is Cool and Switched off, Before
Changing Bulbs.
 Do Not use Bulbs Exceeding Maximum Wattage , As Per
Caution Label.
 Do Not Touch the Bulbs or Protective Glass while fixture is
in operation.
 Do not operate fixture next to combustible material.
 Do not use lamps without the Supplied Tempered Glass
Shields
***READ & SAVE THESE INSTRUCTIONS ***
ACCESS LIGHTING
MODEL 52042
INSTALLATION & OPERATION INSTRUCTIONS
1) TOOLS AND MATERIALS REQUIRED
 Blade Screwdriver
 Star Screwdriver
 Wire Cutters
 Wiring supplies as required by Electrical Code
 Step Ladder
Attention:
Before assembling your lighting fixture, please read
the following instructions. If you feel you do not
have sufficient electrical experience, refer to a do-it-
yourself wiring handbook or have your fixture
installed by a qualified licensed electrician.
(2) GENERAL
1. To ensure the success of the installation, be sure to read these
instructions thoroughly before beginning.
2. All electrical connections must be in accordance with local
codes, ordinances, or the National Electrical Code. If you are
unfamiliar with methods of installing electrical wiring, secure the
services of a qualified licensed electrician.
3. These fixtures are intended for mounting to a standard 4” x 2 ¼”
deep metal octagon outlet box. The box must be directly
supported by the building structure and U.L Recognized.
4. Before commencing with the installation, disconnect the
power by turning off the circuit breaker or by removing the
fuse at the fuse box. Turning the power off using the light
switch is not sufficient to prevent electrical shock.
NOTE:
The important safeguards and instructions appearing in
this manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense, caution and care, are
factors that cannot be built into any product. The
person(s) caring for and operating the fixture must
supply these factors.
(3) UNPACKING THE FIXTURE
On checking the contents of the box you will find;
1. Mounting Hardware Package
2. Glass Diffuser
3. Mounting Plate
4. Fixture Assembly
5. 5 x GU-10/35W/HGN/120V
Support Bracket (d)
Paper Template (c)
a c c e s s
L I G H T I N G