Installation Guide

MAKE WIRE CONNECTION
If there is an existing fixture remove it. Expose the
supply wires from the J-box. Mount the crossbar to
the J-box with the supplied screws. Gently pull the
supply wires through the hole in the crossbar plate.
Connect the black supply wire to the black fixture wire.
Secure with the supplied wire nuts. Connect the white
supply wire to the white fixture wire. Secure with the
supplied wire nuts. Attach the green J-Box wire around
green hexagonal head screw or connect it to the green
supply grounding wire of the fixture. Secure all wires
with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
1
WHAT YOU NEED
•
Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
2
2
CERTIFICATION: cULus DRY NO. 50942LEDD
3
MOUNT THE CANOPY TO THE
CROSSBAR
Fit the fixture canopy up to the crossbar. Insert the
hanging screw into the designated hole in the fixture.
Secure with the supplied screw knob.
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION
VER: 19.01.1