Installation Sheet

CERTIFICATION: CETL DAMP NO. 31002,03,06,07LEDD
CONNECT THE WIRES
Connect the black supply wire to the black fixture
wire. Secure with the supplied wire nuts. Connect
the white supply wires to the fixture wire. Secure
with the supplied wire nuts. Attach the ground green
wire from the fixture to the outlet box ground
terminal (or to the box ground wire) Secure all wire
with U.L Certified electrical tape (not supplied).
Tuck all wires carefully into the J-box.
2
MOUNT THE CANOPY
Determine the best location for your fixture. Position
the Floating Back Plate as desired, mark screw holes
with a pencil and then drill holes. Place the supplied
Screw Plugs into the holes. Insert Nipple through the
Center Hole in the Metal Plate. Now fit the Nipple
through the closest hole available in the Floating
Back Plate. Secure with the supplied Nut.
Secure the Floating Back Plate to the wall with the
supplied Screws.
Fit the Fixture Plate over the Floating Back Plate
ensuring that the two holes on either end of both
plates are aligned. Secure with the supplied Screws.
3
SECURE THE GLASS SHADE
Secure the Glass Diffuser by fitting the
Screws on the face of the Fixture Plate
through the holes allocated in the Glass
Diffuser. Secure with the supplied Brass Nuts
and Washers.
4
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF
YOUR NEW ACCESS LIGHTING
FIXTURE
5
Screw plugs
Screws x2
Glass Diffuser
Brass Nuts
& Washers
CAUTION
If the fixture is to be removed or replaced, please ensure
that the electricity is switched off and that the fitting is cool
before touching it.
2
Screws x2
Nut
Wire Nuts x3
Screws x4
Nut
Floating Back
Plate