Installation Guide

ManualsBrandsAccess Lighting ManualsBathroom LightingAccess Lighting Vail 26" Wide Integrated LED Bath Bar - 2700K

CERTIFICATION: CETL DAMP NO. 30001,01LEDD

INSTALLATION INSTRUCTIONS

IMPORTANT

Before assembling your access lighting fixture, please make sure

that you carefully read through these instruction sheets. Consider

having your fixture installed by a qualified licensed electrician.

NOTE: The important safeguards and instructions that appear in

the manual are not meant to cover all possible conditions and

situations that may occur. It must be understood that common sense,

caution and care are factors that can’t be built into any product.

These factors must be supplied by the person(s) caring for and

operating the fixture.

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to standard 4” x 2 ½” metal octagon outlet box. The box

must be directly supported by the building structure and U.L

Recognized.

STEP-BY-STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off

the Circuit Breaker or by removing the fuse at the fuse box. Just

turning the light off at the light switch is not sufficient to prevent

electrical shock.

APPLICATION

Wall Vanity

(Dimmable)

MODEL NO.

31000,01LEDD

COLLECTION

Vail

PREPARE FIXTURE

If there is an existing fixture remove it.

Expose the supply wire from the outer box.

Secure the crossbar to the J-box with the

supplied screws. Make sure that the Nipple

already inserted into the Crossbar faces

outward.

Fit the Fixture Wires through the outer hole

in the Metal Plate.

WHAT WE PROVIDE

 Back Plate

 Mounting

Hardware

 1 x Glass Shade

 LED Module

WHAT YOU NEED

 Screwdriver

 Wire Cutters

 Wiring Supplies as

Specified by the

Electrical Code

Screws x2

Nut

Summary of content (2 pages)

PAGE 1
CERTIFICATION: CETL DAMP NO. 30001,01LEDD INSTALLATION INSTRUCTIONS IMPORTANT Before assembling your access lighting fixture, please make sure that you carefully read through these instruction sheets. Consider having your fixture installed by a qualified licensed electrician. NOTE: The important safeguards and instructions that appear in the manual are not meant to cover all possible conditions and situations that may occur.
PAGE 2
CERTIFICATION: CETL DAMP NO. 31000,01LEDD CONNECT THE WIRES Screws x2 Nut 2 Connect the black supply wire to the black fixture wire. Secure with the supplied wire nuts. Connect the white supply wires to the fixture wire. Secure with the supplied wire nuts. Attach the ground green wire from the fixture to the outlet box ground terminal (or to the box ground wire) Secure all wire with U.L Certified electrical tape (not supplied). Wire Nuts x3 Tuck all wires carefully into the J-box.