Installation Guide

WHAT YOU NEED
•
Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
• 3 x 60W E26 Bulbs (20672)
4
3
CERTIFICATION: cULus DAMP NO. 20672/20672LEDDLP
5
6
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that might exceed the
maximum wattage, stated on caution label.
CAUTION
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
INSERT THE BULBS
Insert the bulbs .
DO NOT EXCEED THE MAXIMUM WATTAGE
AS STATED ON THE WARNING LABEL.
SECURE GLASS SHADE
Loosen the screws holding the glass support clips
so that the clips can be adjusted. Fit each clip under
the shelf in the glass and secure by tightening down
the glass support clips.
VER: 18.11.1