Installation Guide

CERTIFICATION: cULus DAMP
NO. 20662LEDDLP
2
1
MOUNT THE CROSSBAR
If there is an existing fixture remove it. Expose the supply
wires from the J-box. Mount the crossbar to the J-box with
the supplied screws.
2
MAKE THE WIRE CONNECTIONS
Gently pull the supply wires through the hole in the
crossbar plate. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts. Connect
the white supply wire to the white fixture wire. Secure with
the supplied wire nuts. Attach the green J-Box wire around
green hexagonal head screw or connect it to the green
supply grounding wire of the fixture. Secure all wires with
electrical tape (not supplied). Tuck all wires carefully into
the J-box
3
MOUNT THE CEILING PAN
Insert the nipple into the central hole of the crossbar and
adjust to suitable length. Fasten the hex nut against the
nipple so that the nipple will not rotate further. Position
the ceiling pan against the ceiling ensuring that the nipple
passes through the center hole of the ceiling pan. Secure
the ceiling pan against the celing by screwing the
decorative cap onto the nipple.
4
INSERT THE BULBS
Insert the bulbs
DO NOT EXCEED THE RECOMMENDED
WATTAGE AS STATED ON THE WARNING LABEL..