Installation Guide

PREPARE FIXTURE
If there is an existing fixture remove it.
Expose the supply wires from the J-box .
Connect the black supply wire to the black fixture wire.
Secure with the supplied wire nut. Connect the white supply
wire to the white fixture wire. Secure with the supplied wire
nut. Either wrap the green wire around one of the
protruding screws or connect it to the supply ground wire.
Secure all wires with U.L. Certified electrical tape (not
supplied). Tuck all wires carefully into the J-Box.
1
2
4
2
CERTIFICATION: cETLus DAMP NO. 20470LEDD/20471LEDD/20472LEDD
3
MOUNT THE FIXTURE
Mount the fixture canopy up to the crossbar.
Secure with the supplied screw knobs.
Place metal frame over the acrylic shade and hold up
to the canopy aligning the holes with the threaded rods.
Secure with the supplied nuts.
MOUNT THE CROSSBAR
Mount the crossbar up to the J-box.
Secure with the supplied screws.
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION
VER: 18.12.1