Installation Guide

ManualsBrandsAccess Lighting ManualsCeiling FixturesAccess Lighting Solero Single Light 18" Wide Integrated LED Flush Mount Bowl Ceiling Fixture

PREPARE FIXTURE

If there is an existing fixture remove it.

Expose the supply wires from the J-box .

Connect the black supply wire to the black fixture wire.

Secure with the supplied wire nut. Connect the white supply

wire to the white fixture wire. Secure with the supplied wire

nut. Either wrap the green wire around one of the

protruding screws or connect it to the supply ground wire.

Secure all wires with U.L. Certified electrical tape (not

supplied). Tuck all wires carefully into the J-Box.

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

•

Mounting Hardware

•

1 x Acrylic Shade

•

1 x Metal frame

•

LED

COLLECTION

CERTIFICATION: cETLus DAMP NO. 20464LEDD/20465LEDD/20466LEDD/20467LEDD

SOLERO 20464LEDD

20465LEDD

20466LEDD

20467LEDD

APPLICATION MODEL NO.

Ceiling

IMPORTANT

Before assembling your ACCESS LIGHTING fixture, please make sure that

you carefully read through this instruction sheet.

CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH

CIRCUIT CONDUCTOR.

CONSULTER UN ELECTRICIEN QUALIFIE POUR VOUS ASSURER QUE LES

CONDUCTEURS DE LA DERIVATION SONT ADEQUATS

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE

INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONTSTRUCTION

AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

CE PRODUIT DOIT ETRE INSTALLE SELON LE CODE D’INSTALLATION PERTINENT,

PAR UNE PERSONNE QUI CONNAIT BIEN LE PRODUIT ET SON FONCTIONNEMENT

AINSI QUE LES RISQUES INHERENTS

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box

must be directly supported by the building structure and U.L. Recognized.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

Summary of content (2 pages)

PAGE 1
CERTIFICATION: cETLus DAMP NO. 20464LEDD/20465LEDD/20466LEDD/20467LEDD INSTALLATION INSTRUCTIONS IMPORTANT Before assembling your ACCESS LIGHTING fixture, please make sure that you carefully read through this instruction sheet. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR.
PAGE 2
CERTIFICATION: cETLus DAMP NO. 20464LEDD/20465LEDD/20466LEDD/20467LEDD 2 3 4 2 MOUNT THE CROSSBAR Mount the crossbar up to the J-box. Secure with the supplied screws. MOUNT THE FIXTURE Mount the fixture canopy up to the crossbar. Secure with the supplied screw knobs. Place metal frame over the acrylic shade and hold up to the canopy aligning the holes with the threaded rods. Secure with the supplied nuts.