Installation Guide
(4) PREPARE THE FIXTURE
1. If you are replacing an existing fixture, disconnect and remove
the old fixture. Expose the supply wiring from the outlet box.
2. Lay the un-assembled fixture on a soft surface and carefully
remove all the packing material.
3. Mount the supplied crossbar (2) to the Junction box (1) with the
supplied screws (3) and attach the small threaded rod (6) into
the center hole of the crossbar, with approximately 4 rotations.
4. Attach the Supply Wires to the Fixture Wires in the following
manner. The Black supply wire attaches to the Black or
Brown fixture wire and the White or Blue supply wire
attaches to the White fixture wire. Attach the Green/Ground
wire from the fixture to the Electrical Supply Wire.
5. Secure these connections with supplied Wire Nuts (3) and tape
these connections with electrical tape (not supplied)
6. Attach the Fixture (8) to the threaded rod protruding from the
crossbar and secure with the supplied knurled knob (9), when
doing so make sure the fixture is in an upright position, as the
glass shade slides down into the frame.
7. Attach the glass by sliding it gently into the slots of the fixture
until it seats comfortably into position.
8. Restore electricity and enjoy your new lighting fixture.
CAUTION:
No user serviceable parts, this fixture uses matched
components, do not attempt to replace any components or
repair the fixture without seeking advise from the factory.
***READ & SAVE THESE INSTRUCTIONS ***
ACCESS LIGHTING
MODEL # 20416 / 20420
INSTALLATION & OPERATION INSTRUCTIONS
1) TOOLS AND MATERIALS REQUIRED
Blade Screwdriver
Star Screwdriver
Wire Cutters
Wiring supplies as required by Electrical Code
Attention:
Before assembling your lighting fixture, please
read the following instructions.
(2) GENERAL
1. To ensure the success of the installation, be sure to read these
instructions thoroughly before beginning.
2. All electrical connections must be in accordance with local
codes, ordinances, or the National Electrical Code. If you are
unfamiliar with methods of installing electrical wiring, secure the
services of a qualified licensed electrician.
3. These fixtures are intended for mounting to a standard 4” x 2 ¼”
deep metal octagon outlet box. The box must be directly
supported by the building structure and U.L. Recognized.
4. Before commencing with the installation, disconnect the power
by turning off the circuit breaker or by removing the fuse at
the fuse box. Turning the power off using the light switch is not
sufficient to prevent electrical shock.
NOTE:
The important safeguards and instructions appearing in
this manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense, caution and care, are
factors that cannot be built into any product. The
person(s) caring for and operating the fixture must
supply these factors.
(3) UNPACKING THE FIXTURE
On checking the contents of the box you will find;
1. Hardware Packet
2. Fixture
3. Glass Shade