Installation Sheet

PREPARE FIXTURE AND MOUNT
CROSSBAR PLATE
If there is an existing fixture remove it.
Expose the supply wires from the J-box. Screw the
supplied crossbar to the J-box using the supplied screws.
Gently pull the supply wires through the center hole
in the crossbar. Slide the fixture wires through the hole
in the back plate.
1
WHAT YOU NEED
•
Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
2
4
2
CERTIFICATION: cULus WET NO. 20350MG/20350LEDDMGLP
3
CONNECT THE WIRES
Connect the black supply wire to the black fixture wire.
Secure with the supplied wire nuts. Connect the white
supply wire to the white fixture wire. Secure with the
supplied wire nuts. Attach the green J-Box wire around
green hexagonal head screw or connect it to the green
supply grounding wire of the fixture. Secure all wires
with UL Certified electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
Fit the supplied gasket onto the back plate. Align the
designated holes on both back plate and fixture and mount
to the crossbar with supplied screws.
INSERT THE BULB AND COVER
I nsert the supplied bulb and cover.
DO NOT EXCEED THE MAXIMUM WATTAGE AS
STATED ON THE WARNING LABEL.
** This fixture is wet location rated. In order to ensure
that moisture does not enter the outlet box and cause
a short circuit, clear caulking should be used to seal the
space between the fixture mounting bracket and the
wall. Ensure that a space is left at the bottom to allow
for the escape of moisture. It is recommended that
Outdoor Silicon Sealant is used for that purpose**
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that might exceed the
maximum wattage, stated on caution label.
CAUTION
VER: 18.11.1