Instructions / Assembly

CERTIFICATION: cETLus WET NO.

20125LEDDMG/20126LEDDMG

PREPARE FIXTURE AND ATTACH

MOUNTING BRACKET

If there is an existing fixture remove it. Expose the

supply wires from the J-box. Gently pull the supply

wires through the center of the mounting bracket.

Secure the mounting bracket to the J-box with the

supplied screws.

MAKE WIRE CONNECTION

Connect the black supply wire to the black driver wire.

Secure with the supplied wire nuts. Connect the white

supply wire to the white driver wire. Secure with the

supplied wire nuts. Attach the green

J-Box wire around green hexagonal head screw or

connect it to the green supply grounding wire of the

fixture. Secure all wires with electrical tape

(not supplied). Tuck all wires carefully into the J-Box.

MOUNT FIXTURE

Align the fixture onto the mounting bracket and secure

with the supplied screws.

**This fixture is wet location rated. In order to ensure

that moisture does not enter the outlet box and cause a

short circuit, clear caulking should be used to seal the

space between the fixture mounting bracket and the

wall. Ensure that a space is left at the bottom to allow

for the escape of moisture. It is recommended that

Outdoor Silicon Sealant is used for that purpose**

RESTORE THE ELECTRICITY AND

CHECK THE OPERATION OF YOUR

NEW ACCESS LIGHTING FIXTURE

If the fixture is to be removed or replaced,

please ensure that the electricity is

switched off and that the fitting is cool

before touching it.

CAUTION

VER: 20.03.1