Installation Guide

1
WHAT YOU NEED
•
Screwdriver
• Wire Cutters
• Wiring Supplies as Specified
by Electrical Code
2
4
2
CERTIFICATION: cETLus WET NO. 20084LED
3
MOUNT CROSSBAR PLATE
If there is an existing fixture remove it.
Expose the supply wires from the J-box.
Mount the crossbar plate to the J-box with the
supplied screws.
MAKE WIRE CONNECTIONS
Gently pull the supply wires through the hole in the
crossbar. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts.
Connect the white supply wire to the white fixture
wire. Secure with the supplied wire nuts. Attach the green
J-Box wire around green hexagonal head screw or connect
it to the green supply grounding wire of the fixture.
Secure all wires with UL Certified electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
MOUNT THE FIXTURE
Place the fixture up to the crossbar and align with the
sides holes of the canopy and secure with the
supplied allen screws.
This fixture is wet location rated. In order to ensure
that moisture does not enter the outlet box and cause
a short circuit, clear caulking should be used to seal the
space between the fixture mounting bracket and the
mounting surface. It is recommended that
Outdoor Silicon Sealant is used for that purpose**
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION
VER: 18.10.1