Installation Guide

1
2
4
2
CERTIFICATION: cETLus WET NO. 20082LED/20083LED
3
PREPARE THE FIXTURE
If there is an existing fixture remove it.
Use the provided paper template to mark the location of
the provided concrete anchors.
Drill the holes using a 3/8" drill bit and insert the anchors.
MAKE WIRE CONNECTIONS
Connect the black supply wire to the black fixture wire.
Secure with the supplied wire nuts. Connect the white supply
wire to the white fixture wire. Secure with the supplied wire
nuts. Attach the green ground wire around green hexagonal
head screw or connect it to the green supply grounding wire
of the fixture. Secure all wires with UL Certified electrical
tape (not supplied).
Tuc k all wires carefully into the J-Box.
MOUNT THE FIXTURE
Align the fixture base to the previously installed
anchors and secure with the provided anchor screws.
** This fixture is wet location rated. In order to ensure
that moisture does not enter the outlet box and cause
a short circuit, clear caulking should be used to seal the
space between the fixture mounting bracket and the
mounting surface. It is recommended that
Outdoor Silicon Sealant is used for that purpose**
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION
VER: 19.04.1