Instructions / Assembly

ManualsBrandsAccess Lighting ManualsCeiling LightsUlko Exterior 7-in Silver Modern/Contemporary LED Flush Mount Light

Table Of Contents

CERTIFICATION:

cETLus Wet

NO. 20075LEDD/20076LEDD

INSTALLATION INSTRUCTIONS

IMPORTANT

Before assembling your ACCESS LIGHTING fixture, please make sure that

you carefully read through this instruction sheet.

CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH

CIRCUIT CONDUCTOR.

CONSULTER UN ELECTRICIEN QUALIFIE POUR VOUS ASSURER QUE LES

CONDUCTEURS DE LA DERIVATION SONT ADEQUATS

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE

INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONTSTRUCTION

AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

CE PRODUIT DOIT ETRE INSTALLE SELON LE CODE D’INSTALLATION PERTINENT,

PAR UNE PERSONNE QUI CONNAIT BIEN LE PRODUIT ET SON FONCTIONNEMENT

AINSI QUE LES RISQUES INHERENTS

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

COLLECTION

APPLICATION MODEL NO.

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box

must be directly supported by the building structure and U.L. Recognized.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

WHAT WE PROVIDE

•

Mounting Hardware

• Canopy

• 1 x Acrylic shade

• LED

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

Junction

box

Crossbar

PREPARE FIXTURE AND MOUNT

CROSSBAR

If there is an existing fixture remove it.

Expose the supply wires from the J-box.

Mount the crossbar to the junction box with the

supplied screws.

Screw

Dimmable fixture - see attached list for compatible dimmer switches.

Wall/Ceiling Flush Mount

ULKO

20075LEDD

20076LEDD

Summary of content (2 pages)

PAGE 1
CERTIFICATION: cETLus Wet NO. 20075LEDD/20076LEDD INSTALLATION INSTRUCTIONS IMPORTANT Before assembling your ACCESS LIGHTING fixture, please make sure that you carefully read through this instruction sheet. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR.
PAGE 2
CERTIFICATION: cETLus Wet NO. 20075LEDD/20076LEDD SUPPORT THE FIXTURE AND MAKE WIRE CONNECTIONS Hook the support wire to hold the fixture while you 2 Note: round shade shown make the electrical connection. Gently pull the supply wires through the hole in the crossbar. Connect the black supply wire to the black fixture wire. Secure with the supplied wire nuts. Connect the white supply wires to the white fixture wire. Secure with the supplied wire nuts.