Installation Guide

2
4
2
CERTIFICATION: cETLus Wet NO. 20070LEDD/20071LEDD/20072LEDD
3
SUPPORT THE FIXTURE AND MAKE
WIRE CONNECTIONS
Hook the support wire to hold the fixture while you
make the electrical connection.
Gently pull the supply wires through the hole in the
crossbar. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts.
Connect the white supply wires to the white
fixture wire. Secure with the supplied wire nuts. Either
wrap the green wire around one of the protruding screws
or connect it to the supply ground wire. Secure all wire
with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
MOUNT FIXTURE
Align the acrylic shade with the crossbar and push the
clips into the key holes.
WARNING: if not pushed in place, the
fixture may fall and cause serious
injury.
** This fixture is wet location rated. In order to ensure
that moisture does not enter the outlet box and cause
a short circuit, clear caulking should be used to seal the
space between the fixture mounting bracket and the
wall. Ensure that a space is left at the bottom to allow
for the escape of moisture. It is recommended that
Outdoor Silicon Sealant is used for that purpose**
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION