Installation Sheet

2
4
2
CERTIFICATION: UL WET NO. 20046LEDDMG
3
WIRE CONNECTIONS
Connect the black supply wire to the black fixture wire.
Secure with the supplied wire nuts. Connect the white
supply wires to the white fixture wire. Secure with the
supplied wire nuts. Either wrap the green wire around
one of the protruding screws or connect it to the supply
ground wire.
Secure all wires with electrical tape (not supplied).
Tuck all wires and LED driver carefully into the J-Box.
MOUNT FIXTURE TO CROSSBAR
Position the fixture over the crossbar.
Align the hole at the bottom of the fixture and secure
with the supplied screw.
** This fixture is wet location rated. In order to ensure
that moisture does not enter the outlet box and cause
a short circuit, clear caulking should be used to seal the
space between the fixture mounting bracket and the
wall. Ensure that a space is left at the bottom to allow
for the escape of moisture. It is required that Indoor/
Outdoor Silicon Sealant be used for that purpose**
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
If the fixture is to be removed or replaced,
please ensure that the electricity is
switched off and that the fitting is cool
before touching it.
CAUTION