Installation Guide

1
2
4
2
CERTIFICATION: cETLus WET NO. 20010MG/20010LEDDMGLP
3
MOUNT STRAIGHT BAR AND WIRE
CONNECTIONS
If there is an existing fixture remove it. Expose the supply
wire from the J-box.
Mount the straight bar to the J-box with
the supplied screws. Connect the black supply wire to the black
fixture wire. Secure with the supplied wire nuts. Connect the
white supply wire to the white fixture wire. Secure with the
supplied wire nuts. Attach the green J-Box wire around
green hexagonal head screw or connect it to the green
supply grounding wire of the fixture.
Secure all wire with electrical tape (not supplied).
Tuck all wires carefully into the J-Box.
MOUNT FIXTURE TO STRAIGHT BAR
AND INSERT THE BULB
Position the fixture plate over the straight bar.
Align the center hole of the plate and secure with the
supplied screw knob.
insert the bulb.
DO NOT EXCEED THE MAXIMUM WATTAGE AS STATED
ON THE WARNING LABEL.
SECURE THE GLASS SHADE AND METAL
FRAME
Position the glass shade and metal frame over the
fixture plate. Align the holes of the plate and
secure with the supplied screws.
**This fixture is wet location rated. In order to ensure
that moisture does not enter the outlet box and cause
a short circuit, clear caulking should be used to seal the
space between the fixture mounting bracket and the
wall. Ensure that a space is left at the bottom to allow
for the escape of moisture. It is recommended that
Outdoor Silicon Sealant is used for that purpose**
Please ensure that the fitting is cool and
switched off before replacing the bulb.
DO NOT use bulbs that might exceed the
maximum wattage, stated on caution label.
CAUTION
RESTORE THE ELECTRICITY AND
CHECK THE OPERATION OF YOUR
NEW ACCESS LIGHTING FIXTURE
VER: 18.11.1