Troubleshooting guide

Rev: March 2, 2009 Access HD is a registered trademark of GXI International, LLC 2 of 7
Converter will not turn on.
Is a green or red LED on the front panel lit up?
Make sure unit is plugged in and outlet has power.
Takes a while for unit to
display anything on TV
System has to finish the initialization of the main chip (boot-up
time).
Unit is frozen or locked up.
Unplug unit from the power outlet for 2-3 hours to do a hard reset.
Plug unit back in press the power button to turn it on.
Press the Power button on the front panel of unit.
No picture on TV screen
Make sure power is on (Green LED/Light on) and the TV is
powered on
Make sure RF cable is connected properly and securely, from the
converter’s RF OUT to the to the TV’s RF (ANT) IN.
Make sure yellow RCA video cable is connected properly and
securely.
Make sure the correct channel is chosen on the converter box and
the TV (both to CH3 or both to CH4).
Make sure yellow RCA video cable is connected properly and the
correct input has been selected on the TV (LINE IN, VIDEO IN, etc)
Power and Display - Troubleshooting
No picture, I only see a solid
Green, Blue, or Black on the
screen.
Unplug power cord and plug it back in.
My converter always turns off
by itself.
The default setting from the factory is set to put the converter in
standby in 4 hours to save electricity. You may change it to 2, 4, or
disable it (Off).
The settings for “Auto Power Down Timer” stay the same even
after the unit has been put in standby mode. Leave on 1, 2, 3, or 4
to save electricity in case you forget to turn the unit to standby after
turning off the TV.
If you are able to scan channels
successfully, but after turning the
unit off, you see a message that
says please scan channels when
the unit is powered up again.
You may have a memory component failure. To process a warranty
claim for this issue, you can return the unit to us with the M E M
101 written on the package. Include a copy of your purchase
receipt, your daytime telephone number and your return shipping
address. There is no return handling charge for this process. You
can also use the Advance exchange option if you prefer.