Technical information

V4 Logger95

37 connectors on the back also and you may install a straight through

StarGuide II/III to GPI 32 cable for convenience. Either connection will

produce the same results.

The screen shot below shows the ASCII text on the Hyper Terminal screen

for the first 16 closures that were manually forced. If you are not seeing

any text on the screen, verify that the GPI 32 DIP switch settings have

position 5 and 6 in the up or on position and the rest of the switches down

or in the off position. Also verify your settings including COM port are

correct in Hyper Terminal.

If you can see populating the field then you have verified the COM is

working correctly. If the closures are not being recognized with a

functional COM port, then verify your configuration settings are set

properly in ONAIR or Logger.

To Recap:

Install the Virtual Serial Driver required for the supplied USB cable.

Select the COM port you have configured for the VCP (Virtual COM Port).

Configure the closure device in either ONAIR or Logger as the SRC 32.

The GPI 32 uses the same “PIP” codes as used with the SRC 32.

We hope you find this guide useful. If you have any questions or

comments about this guide you can contact OMT support at

1-800-726-2635 or Sales at 1-888-665-0501.