Technical information

V4 Logger91

LOGGER CONFIGURATION

Once the VCP software is installed (see previous driver setup), configuring

Logger is relatively simple. Start the Logger application and from the top

left corner, click on “Configure” then “Hardware”.

You should see the following display.

Enable the SRC 32 device as the input codes are the same as the GPI 32

and select the appropriate COM port. You will need to restart your Logger

application once you have saved your configuration settings.

Under “Feeds” from the main Logger display, select the feed you wish to

apply closure and configure under “Input Closures” and select the SRC 32

device from the drop down list of closure devices available.

Verify you are receiving all closures through the “Event Log” tab form the

Logger main display. From the top left corner of the main Logger display,

select “Tools’ then “Configure” and enable all events Logging from the

“Administration” tab.