Technical information

V4 Logger User Guide 86

INSTALLATION

Please read the Broadcast Tools GPI 32 manual before installing this

device as it will provide an outline of how the device functions and its

requirements. The following is an excerpt from the Broadcast Tools

manual.

The GPI-32 interfaces 32 optically isolated inputs to a users PC's RS-232 or USB port. The serial

data conforms to our standard switcher PIP format. The GPI-32 is equipped with dual plug-in

Euroblock connectors and two independent DB-37 connectors that may be interfaced directly to the

DB-37 connectors located on the StarGuide II/III relay cards. Additional features: dual RS-232

connectors, one for daisy-chaining multiple units on the same legacy serial port and a DB-9 to

interface to our supplied USB adapter; LED indicators for power and input activity; twin power

connectors allowing up to four units to be driven off of one power transformer. The GPI-32 is

supplied with two 3-foot mating DB-37 connecterized cables, serial cable and wall transformer. The

GPI-32 is powered by a surge protected internal power supply. The GPI-32 may be mounted on the

optional RM-3 mounting shelf.

Maintain proper installation techniques including UPS, static and lightning

protection and proper wiring standards. If you are running extender

cables, be sure to take RF, line voltage, distances and proper shielding

techniques into consideration as this can affect the performance of both

out software and this device.

BEFORE POWERING UP THE GPI 32

There are two Phillip #2 screws on the top of the Broadcast Tools unit that

will need to be removed to adjust the “DIP” switches. Switch 5 and 6

should be set in the up or on position and remaining switches in their

default or off state. Replace the cover when complete.

BEFORE YOU CONNECT THE GPI 32 TO YOUR COMPUTER VIA USB

TO 9 PIN CABLE

You can save time by downloading the Virtual Com Port driver (VCP) to a

folder on your ONAIR or Logger computer. “Unzip” or “Extract” the USB

Serial driver files before rebooting your computer with the

hardware attached. You will require a USB Serial device driver and OMT

Support have verified that Royalty Free drivers are available at: